Several things you must know when choosing a high-pressure nozzle
To choose a nozzle, you need to recognize some of the nozzle parameters.
In a direct pressure nozzle, the fine liquid column ejected from the nozzle hole hits the target needle with the same diameter as the nozzle hole diameter facing it, and then forms a very fine atomization. In some applications, this nozzle even replaces Many expensive two-fluid air atomizing nozzles that use compressed air or water vapor as the second fluid.
The nozzle hole diameter is between 0.1 ㎜-0.5 ㎜, and under the pressure of 5kg-30kg, the nozzle forms a very fine atomization, which can be widely used in artificial fog, livestock farms, greenhouses and other applications that require humidification spray. On occasions, the power consumption is 3W per kilogram of fog, and the use cost is extremely low. The nozzle hole diameter is between 0.1mm and 0.5mm. Under the pressure of 5kg and 30kg, the nozzle forms a very fine atomization, which can be widely used in artificial fog, livestock farms, greenhouses and other humidification applications. In the case of spraying, the power consumption is 3 watts per kilogram of fog, and the use cost is extremely low.
Design Features:
●High energy efficiency
●Small pressure/flow ratio
●No internal parts design, strong anti-blocking ability
●Strong atomization ability
●The spray density is saddle-shaped
●Solid cone spray
●Teflon filter or 10 micron stainless steel filter can be attached
Commonly used materials: 304SS, 316SS, 316L
Spray performance:
●The finest atomization among all direct pressure nozzles
●The size of the atomized droplets provided is less than 50 microns
●Conical atomization
